Using University Videoconferencing Systems
Many units use videoconferencing systems for audio and video conferencing.
Registering a Unit Telepresence System
Units on campus can register their videoconferencing room systems in the university video cluster using SIP at no cost. This allows units to assign a university phone number to the system vs. an IP address. For more information, see Connect Your Unit's Systems to the ITS Enhanced Videoconferencing Network.
Determining Telepresence System Options
Press the * key on your Videoconference System Remote Control to display available menu and layout options.
Connecting to a BlueJeans Meeting from a Video Conference System that is Not Registered in the University Video Cluster
When connecting from a Polycom, Cisco/Tandberg, LifeSize, and Mirial/Clear system that is not registered in the university video cluster, you can dial directly into a BlueJeans meeting using the following instructions:
- Room Systems that are H.323 enabled:
- Use <Meeting ID>.<Passcode>@199.48.152.152
Example, if the meeting ID is 12345 and the passcode is 1111 enter:
[email protected] - If a passcode is not required enter:
[email protected]
- Use <Meeting ID>.<Passcode>@199.48.152.152
- Room Systems that are SIP enabled:
- Use IP: 199.48.152.155 or sip.bjn.vc to get the IVR (Interactive Voice Response) prompt
- URI dialing using domain: <Meeting ID>@sip.bjn.vc or 199.48.152.155
- Older Systems that do not support the dial string format listed above should try:
<IP>##<MeetingID>#<Passcode>
Example: 199.48.152.152##12345#1111 - SX10 Video Conference Systems
Watch this instructional video.